Getting Started Guide
Table Of Contents
- Table of contents
- List of figures
- List of tables
- Introduction
- 1 2110SSB Transceiver compliance
- 2 Your 2110SSB Transceiver
- 3 Preparing the 2110SSB Transceiver for use
- 4 The front panel
- 5 Getting started
- 6 Troubleshooting
- Appendix A— Entering and editing text
- Appendix B— Using Quick Start
- Appendix C— Using the GPS receiver
- Appendix D— Transceiver specifications
- Appendix E— HF radio transmission
- Appendix F— Definitions
- Appendix G— Warranties
- Index
Getting started
2110 SSB Transceiver Getting Started Guide 35
Setting up basics
NOTE
Basic information for the transceiver, such as
channels, self addresses, time and date, and
enabling channels for scanning, should be set up
by your system administrator using the NGT
System Programmer. If Quick Start is enabled
you can enter some of this information (see
page 49, Using Quick Start).