Reference Manual
Table Of Contents
- Appendix A Hot key examples
- Example1: selecting a specific channel
- Example2: displaying an information screen
- Example3: displaying and/or changing a setting in the Control List
- Example4: changing a value to the next value in a list
- Example5: opening a list at the marker entry
- Example6: making a call using a specific entry in the Address List
- Example7: setting up one-touch discreet operation
- Appendix B Get Status calls
- Appendix C Forgotten passwords
- Appendix D Limiting user access
- Introduction
- Syntax for the Message10 entry
- Activating configuration commands in the Message10 entry
- Restricting access to the List Manager
- Restricting access to admin level
- Restricting access to call types
- Enabling the automatic removal of the incoming call pop-up
- Restricting access to holding CALL
- Restricting access to Voice Encryptor features
- Index
2110 SSB Transceiver Reference Manual 335
CODAN
Appendix B Get Status calls
When you make a Get Status call you need to specify whether you want to retrieve
diagnostic or configuration information from the remote station (see Table 46 and
Table 47). You do this by entering the number 1 or 2 in the Message setting when
prompted by the transceiver. You can also pre-type and store these numbers in the
Messages entry in the Control List (see page 225, Messages entry), or create an entry for
the call in the Address List (see page 154, Programming the Address List).
Diagnostic information
To obtain diagnostic information, enter ‘1’ as the message for the Get Status call.
Transceivers from other vendors may obtain diagnostic information from a 2110 SSB
Transceiver by sending an AMD message containing #CMD 1 in a Plain network.
Table 46: Diagnostic information from a Get Status call made to a Codan
transceiver
Information
received
Description
RXnn.n Battery voltage in receive
TXnn.n Battery voltage in transmit
S1=nnn Signal strength of received call (µ EMF)
S2=nnn Signal strength 2 seconds after call was received (µ EMF)
SWRn.n SWR of the antenna
Pnnn Power output of the transmitter (W)
Tnn Temperature (°C)