Reference Manual
Table Of Contents
- Appendix A Hot key examples
- Example1: selecting a specific channel
- Example2: displaying an information screen
- Example3: displaying and/or changing a setting in the Control List
- Example4: changing a value to the next value in a list
- Example5: opening a list at the marker entry
- Example6: making a call using a specific entry in the Address List
- Example7: setting up one-touch discreet operation
- Appendix B Get Status calls
- Appendix C Forgotten passwords
- Appendix D Limiting user access
- Introduction
- Syntax for the Message10 entry
- Activating configuration commands in the Message10 entry
- Restricting access to the List Manager
- Restricting access to admin level
- Restricting access to call types
- Enabling the automatic removal of the incoming call pop-up
- Restricting access to holding CALL
- Restricting access to Voice Encryptor features
- Index
Hot key examples
334 2110 SSB Transceiver Reference Manual
Example 7: setting up one-touch discreet operation
This example shows you how to create a macro that will put your transceiver into
discreet operation.
When you run this macro, the transceiver switches off:
• the internal speaker
• alert tones
• backlighting
• key beeps
This macro is created by joining four macros together.
To create this macro:
1 Log into admin level (for help see page 110, Logging into admin level from user
level).
1 Create separate macros to perform the following tasks:
1 Join the macros together, selecting Speaker as the first macro each time (see
page 247, Joining macros).
1 Rename the Speaker macro to Discreet.
1 Delete the Tones, Dark and Beeps macros.
Control List entry Selected setting Macro action Timing Assign to Name
Cfg Speaker Internal Disabled Set this value Immediately Unassigned Speaker
Cfg Alert Tones Disabled Set this value Immediately Unassigned Tones
Screen Brightness ( + 0) Dark Set this value Immediately Unassigned Dark
Key Beeps Off Set this value Immediately Unassigned Beeps
NOTE
For help see page 330, Example 3: displaying and/or changing a
setting in the Control List.
NOTE
The internal speaker is switched on again by holding MUTE, and the
screen backlighting is changed by pressing . If the user needs to
restore key beeps and alert tones, you should create new macros that
enable the user to switch on these settings (see page 330, Example 3:
displaying and/or changing a setting in the Control List).