Reference Manual
Table Of Contents
- Appendix A Hot key examples
- Example1: selecting a specific channel
- Example2: displaying an information screen
- Example3: displaying and/or changing a setting in the Control List
- Example4: changing a value to the next value in a list
- Example5: opening a list at the marker entry
- Example6: making a call using a specific entry in the Address List
- Example7: setting up one-touch discreet operation
- Appendix B Get Status calls
- Appendix C Forgotten passwords
- Appendix D Limiting user access
- Introduction
- Syntax for the Message10 entry
- Activating configuration commands in the Message10 entry
- Restricting access to the List Manager
- Restricting access to admin level
- Restricting access to call types
- Enabling the automatic removal of the incoming call pop-up
- Restricting access to holding CALL
- Restricting access to Voice Encryptor features
- Index
Hot key examples
2110 SSB Transceiver Reference Manual 333
Example 6: making a call using a specific entry in the Address List
This example shows you how to create a macro to make a call using a specific entry in
the Address List.
When you run this macro, the transceiver:
• opens the Address List
• goes to the entry specified in the macro
• begins a call to the address specified in the entry
The timing with which this macro operates is Immediately. This means that the macro
begins the call without displaying the Address List entry first. The transceiver may,
however, prompt you for information about the call depending on the details supplied in
the entry.
To create this macro:
1 Press VIEW until the Address List is displayed.
1 Scroll to the entry you want the macro to call.
1 Hold to open the List Manager.
1 Scroll to Macros..., then press .
1 Scroll to Create macro, then press .
The transceiver asks you to select the action you want the macro to perform.
1 Scroll to Go to this entry, then press .
The transceiver asks you to select the timing with which the macro operates.
1 Scroll to Immediately, then press .
1 Press the key to which you want to assign the new macro.
1 Scroll to the macro that you want to have in the list immediately after the new
macro, then press .
1 Type a name for the macro, then press .
The macro is created and assigned to the key, and the List Manager remains open.