Reference Manual
Table Of Contents
- Appendix A Hot key examples
- Example1: selecting a specific channel
- Example2: displaying an information screen
- Example3: displaying and/or changing a setting in the Control List
- Example4: changing a value to the next value in a list
- Example5: opening a list at the marker entry
- Example6: making a call using a specific entry in the Address List
- Example7: setting up one-touch discreet operation
- Appendix B Get Status calls
- Appendix C Forgotten passwords
- Appendix D Limiting user access
- Introduction
- Syntax for the Message10 entry
- Activating configuration commands in the Message10 entry
- Restricting access to the List Manager
- Restricting access to admin level
- Restricting access to call types
- Enabling the automatic removal of the incoming call pop-up
- Restricting access to holding CALL
- Restricting access to Voice Encryptor features
- Index
Hot key examples
330 2110 SSB Transceiver Reference Manual
Example 3: displaying and/or changing a setting in the Control List
This example shows you how to create a macro to display and/or change a setting in the
Control List. You can then change the value or press to leave it as it is.
When you run this macro, the transceiver:
• goes to the Cfg Alert Tones entry in the Control List
• displays the current value
• waits for you to act
To create this macro:
1 Log into admin level (for help see page 110, Logging into admin level from user
level).
1 Press until Main Menu is displayed.
1 Scroll to Control, then press .
1 Scroll to Cfg Alert Tones, then hold .
A question mark is displayed at the end of the top line to indicate that you can now
change the value.
1 Hold to open the List Manager.
1 Scroll to Macros..., then press .
1 Scroll to Create macro, then press .
The transceiver asks you to select the action you want the macro to perform.
1 Scroll to Display value, then press .
The transceiver asks you to select the timing with which the macro operates.
1 Scroll to Waits, then press .
1 Press the key to which you want to assign the new macro.
1 Scroll to the macro that you want to have in the list immediately after the new
macro, then press .
1 Type a name for the macro, then press .
The macro is created and assigned to the key, and the List Manager remains open.