Reference Manual
Table Of Contents
- Appendix A Hot key examples
- Example1: selecting a specific channel
- Example2: displaying an information screen
- Example3: displaying and/or changing a setting in the Control List
- Example4: changing a value to the next value in a list
- Example5: opening a list at the marker entry
- Example6: making a call using a specific entry in the Address List
- Example7: setting up one-touch discreet operation
- Appendix B Get Status calls
- Appendix C Forgotten passwords
- Appendix D Limiting user access
- Introduction
- Syntax for the Message10 entry
- Activating configuration commands in the Message10 entry
- Restricting access to the List Manager
- Restricting access to admin level
- Restricting access to call types
- Enabling the automatic removal of the incoming call pop-up
- Restricting access to holding CALL
- Restricting access to Voice Encryptor features
- Index
Limiting user access
2110 SSB Transceiver Reference Manual 343
For example, if you want to restrict access to using Message and Get Position call types,
enter the following into the Message 10 entry:
#$! BCT-M,GP
Enabling the automatic removal of the incoming call pop-up
A pop-up message is displayed when you receive an incoming call. This message usually
remains on the display until you acknowledge it by pressing or . When you use the
Timeout Incoming Call (TIC) configuration command, the incoming call pop-up is
removed after 30 seconds.
If you want to automatically remove all incoming call pop-ups after 30 seconds, enter the
following into the Message 10 entry:
#$! TIC
Restricting access to holding CALL
When you hold CALL, you gain access to changing call details as you make a call. If
you want to prevent the user from having access to networks and channels, use the Hold
Call Disable configuration command.
For example, if you want to disable the hold CALL function, enter the following into the
Message 10 entry:
#$! HCD