Reference Manual
Table Of Contents
- Table of contents
- 1 About this manual
- 2 2110SSB Transceiver compliance
- 3 HF radio transmission
- 4 The 2110SSB Transceiver
- 5 Preparing the 2110SSB Transceiver for use
- 6 Operating the transceiver
- 7 Using lists
- 8 The Channel List
- 9 The Network List
- 10 The NETList
- 11 The Phone Link List
- 12 The Address List
- 13 Making and receiving calls
- 14 The Control List
- 15 The Keypad List
- 16 The Mode List
- 17 Using the transceiver in free tune and Amateur Mode
- 18 Hot keys
- 19 Operating the transceiver from a computer
- 20 Connectors
- 21 System messages
- 22 Accessories and hardware options
- 23 Specifications
- Index
- List of figures
- List of tables
- 1 About this manual
- 2 2110SSB Transceiver compliance
- 3 HF radio transmission
- 4 The 2110SSB Transceiver
- 5 Preparing the 2110SSB Transceiver for use
- Charging a battery
- Connecting a battery to the transceiver
- Inserting the transceiver into a backpack
- Selecting an appropriate antenna
- Troubleshooting the transceiver
- Testing the installation
- 6 Operating the transceiver
- Switching on the transceiver
- The front panel screen
- The channel screen
- Entering and editing text
- Quick Start
- Muting the transceiver
- Scanning channels
- Using the microphone
- Finding words and values
- Setting the basics
- Using hot keys
- Tuning the antenna
- Using the clarifier
- Reducing background noise with Easitalk
- Using the voice encryptor
- 7 Using lists
- The Main Menu
- Selecting a list
- The List Manager
- Setting a marker
- Setting the home screen
- Changing a setting in the Control List
- Making changes to all other lists
- Hiding and showing settings
- Grouping and ungrouping entries
- Restricting access to information
- Logging into admin level
- Displaying full and normal view
- Hiding and showing information
- Locking and unlocking information
- 8 The Channel List
- 9 The Network List
Operating the transceiver
2110 SSB Transceiver Reference Manual 79
Reducing background noise with Easitalk
The Easitalk feature enables you to reduce the level of background noise that is present
when you listen to a channel.
If Easitalk is on when the transceiver begins scanning, it is automatically switched off. It
is switched on again when scanning pauses or stops.
Switching Easitalk on or off
To switch Easitalk on or off:
1 Press EASITALK.
The Easitalk entry in the Control List is displayed and the value is automatically
toggled on or off.
After about 2 seconds you are returned to the screen from which you began.
NOTE
Easitalk uses one of three DSP algorithms to reduce the background
noise. Depending on the conditions you may need to change the algorithm
in the Cfg Easitalk entry in the Control List. If you intend to change the
algorithm regularly, set up a hot key on the 5 key to go to the next
algorithm value in the Cfg Easitalk entry in the Control List (see
page 331, Example 4: changing a value to the next value in a list).
NOTE Easitalk is not available if the Voice Encryptor feature is active.