Reference Manual
Table Of Contents
- Table of contents
- 1 About this manual
- 2 2110SSB Transceiver compliance
- 3 HF radio transmission
- 4 The 2110SSB Transceiver
- 5 Preparing the 2110SSB Transceiver for use
- 6 Operating the transceiver
- 7 Using lists
- 8 The Channel List
- 9 The Network List
- 10 The NETList
- 11 The Phone Link List
- 12 The Address List
- 13 Making and receiving calls
- 14 The Control List
- 15 The Keypad List
- 16 The Mode List
- 17 Using the transceiver in free tune and Amateur Mode
- 18 Hot keys
- 19 Operating the transceiver from a computer
- 20 Connectors
- 21 System messages
- 22 Accessories and hardware options
- 23 Specifications
- Index
- List of figures
- List of tables
- 1 About this manual
- 2 2110SSB Transceiver compliance
- 3 HF radio transmission
- 4 The 2110SSB Transceiver
- 5 Preparing the 2110SSB Transceiver for use
- Charging a battery
- Connecting a battery to the transceiver
- Inserting the transceiver into a backpack
- Selecting an appropriate antenna
- Troubleshooting the transceiver
- Testing the installation
- 6 Operating the transceiver
- Switching on the transceiver
- The front panel screen
- The channel screen
- Entering and editing text
- Quick Start
- Muting the transceiver
- Scanning channels
- Using the microphone
- Finding words and values
- Setting the basics
- Using hot keys
- Tuning the antenna
- Using the clarifier
- Reducing background noise with Easitalk
- Using the voice encryptor
- 7 Using lists
- The Main Menu
- Selecting a list
- The List Manager
- Setting a marker
- Setting the home screen
- Changing a setting in the Control List
- Making changes to all other lists
- Hiding and showing settings
- Grouping and ungrouping entries
- Restricting access to information
- Logging into admin level
- Displaying full and normal view
- Hiding and showing information
- Locking and unlocking information
- 8 The Channel List
- 9 The Network List
Operating the transceiver
2110 SSB Transceiver Reference Manual 49
If the transmit and receive frequencies are the same, the frequency is only displayed in
the receive frequency position on the right side of the screen and the Rx indicator arrow
is not used. The signal strength/output power indicator shows whether the transceiver is
receiving or transmitting.
Your transceiver has the option of selecting high or low power by pressing Tx PWR.
When low power is selected, Lo is displayed to the right of the signal strength indicator
(see Figure 9). When high power is selected, Hi is displayed in this location.
While a call is being established, the transceiver will show that calling activity is in
progress by flashing CALL in place of the scan indicator (see Figure 10). During a call,
this indicator is replaced with an icon showing the type of call being sent or received (see
Figure 9). These icons are listed in Table 17 on page 158 and Table 18 on page 166.
When the transceiver is scanning, the channel screen is replaced by the scanning screen
(see Figure 10).
Figure 10: The scanning screen
scan indicator