Reference Manual

The Network List
2110 SSB Transceiver Reference Manual 127
Special network names
Specifying a default network to use with !<network name>
When you make a call from the Channel List, the transceiver usually prompts you to
select a network and channel for the call. To avoid the transceiver prompting you for a
network or channel, the system administrator should set up a network with a leading ‘!’
in the name, for example, ‘!AidNet’. The !<network name> should contain all of the
channels that are programmed into the transceiver, thus avoiding any prompting for
channels.
These networks enable the operator to make a call on any channel in the transceiver with
minimal prompting by the transceiver.
Networks called *CALM, *Selcall and *Voice
These networks are used with Quick Start (see page 57, Quick Start).