Reference Manual

Using lists
110 2110 SSB Transceiver Reference Manual
Logging into admin level
Logging into admin level gives you access to the Admin... group of entries in the List
Manager (see Table 13 on page 92). These entries enable you to lock and hide
information at admin level.
When you log into admin level:
• all locked entries are temporarily unlocked
• full view is enabled
There are two ways you can log into admin level. If you are prompted to enter a
password when you switch on the transceiver, you can enter the admin password instead
of the user password.
You can also log into admin level by logging in at user level then using the Admin login
entry in the List Manager.
Logging into admin level from user level
To log into admin level from user level:
1 Hold to open the List Manager.
If Quick Start is enabled, scroll to Advanced... in the Quick Start menu, then
press .
1 Scroll to Config..., then press .
1 Scroll to Admin login, then press .
1 Enter the admin password, then press .
You are logged into admin level and the List Manager remains open.
1 If you want to access the Main Menu, press until Main Menu is displayed.
Logging out of admin level
To log out of admin level:
1 Hold to open the List Manager.
If Quick Start is enabled, scroll to Advanced..., then press .
1 Scroll to Admin..., then press .
NOTE
If you want to log into admin level this way, make sure that a user and an
admin password have been set in the Control List. When you switch on
the transceiver, you are only prompted to enter a password if a user
password has been set.
NOTE
If an admin password has not been set, you can log in by simply
pressing .