User Manual
Table Of Contents
- 1GENERAL
- 1.1Introduction
- 1.2Performance Specification
- 2THEORY OF OPERATION
- 2.1Amplifier Operation
- 2.2Power Requirements
- 2.3RF Circuitry
- 2.3.1VT-3/150 Lowpass Filter
- 2.4Power Control Circuitry
- 2.5Power Sensing Circuitry
- 2.5.1Output Power Sense
- 2.5.2VSWR Sense
- 2.5.3VSWR Overload
- 3VT-3/150 AMPLIFIER ALIGNMENT
- 3.1General
- 3.2Repair Note
- 3.3Recommended Test Equipment List
- 3.4Printed Circuitboard Numbering Convention
- 3.5Standard Factory Settings and Jumper Configuration
- 3.6VT-3/150 AmplifierAlignment
- 3.6.1General
- 3.6.2VT-3/150 Amplifier Adjustment
- 3.6.2.1General Set-Up
- 3.6.2.2Output Power Alarm (Forward Power)
- 3.6.2.3Output Power
- 3.6.2.4Antenna VSWR Alarm (Reverse Power)
- 3.6.2.5Antenna VSWR Overload
- 3.6.2.6Procedure Verification
- 4ILLUSTRATIONS AND SCHEMATIC DIAGRAMS
- 4.1VT-3/150 VHF Amplifier Component Layout
- 4.2VT-3/150 VHF Amplifier Schematic Diagram
- 4.3VT-3/150 VHF Lowpass Filter Component Layout
- 4.4VT-3/150 VHF Lowpass Filter Schematic Diagram
- 5PARTS LISTS
- 5.1VT-3/150 Amplifier Electrical Parts List
- 5.2VT-3/150 Low Pass Filter Electrical Parts List
- 5.3VT-3/150 Amplifier Mechanical Parts List
- 6REVISION HISTORY
DE
DANIELS
ELECTRONICS
ii
VHF Amplifier Instruction Manual VT-3 132 - 174 MHz
Reviewed By:
Quality
Assurance:
_________________
Name Signature
Date
NOTE:
The
user's
authority
to op
erate
this
equipment
could be revoked through any
changes or
modifications
not expressly approved by
Daniels
Electronics
Ltd.
The design of this
equipment
is subject to change due to continuous
development. This
equipment
may
incorporate
minor changes in
detail
from the
information
contained
in this manual.