User's Manual

MT-4E VHF & UHF Receiver & Transmitter Instruction Manual
IM08-MT-4E-TXRX-P1162
Radio Service Software Programming
6
Installation
The RSS should install automatically once the CD is inserted. If not, run SETUP.EXE, located on
the CD.
NOTE: The receiver and transmitter must be programmed separately.
Once the connections are made, the RSS may be run on the computer and the radio switched on.
The rst time a receiver or transmitter is connected, the USB drivers will need to be installed from the
CD using the Hardware Update Wizard.
To test the connection:
Choose the appropriate module from the Select Device drop-down list.1.
Click 2. Congure on the main screen to open the Receiver or Transmitter Conguration window.
Click 3. Rx ID (or Tx ID).
Click 4. Read.
The serial number, model number, rmware version and last programmed date should appear in the
appropriate elds.
RSS Programming Mode
Programming options are divided into two categories – Global Settings and Channel Settings. When
the receiver or transmitter menu is selected from the main screen, both the global and channel
settings for the current channel are displayed.
The RSS may be used to save a receiver or transmitter conguration to disk. This function allows the
user to save a standard conguration and use it as a starting conguration for all modules. An archive
of congurations from each radio system in operation may also be kept so that replacement radios
can be programmed easily.
NOTE: If the MT-4E Receiver or Transmitter is purchased without the P25 Digital rmware upgrade,
the P25 Digital options will not be available in the RSS.
RSS Service Mode
RSS Service Mode allows tuning, testing and setup of the receiver and transmitter modules. Analog
and P25 Digital test modes, such as Bit Error Rate testing and Test Patterns generation can be
selected by the RSS. Audio Levels, RF Power Output and Reference Oscillator adjustments can also
be performed in RSS Service Mode.