User's Manual
Table Of Contents
- General Information
- Radio Service Software Programming
- Radio System Configurations
- VHF & UHF Receivers and Transmitters
- VHF & UHF Hardware Tuning and Troubleshooting
- VHF and UHF Parts List
- VHF / UHF Receiver Electrical Parts List
- VHF / UHF Receiver Mechanical Parts List
- VHF / UHF Receiver P25 Digital Firmware
- VHF / UHF Receiver and Transmitter Encryption
- VHF / UHF Receiver and Transmitter RSS
- VHF / UHF Transmitter Electrical Parts List
- VHF / UHF Transmitter Mechanical Parts List
- VHF / UHF Transmitter P25 Digital Firmware
MT-4E VHF & UHF Receiver & Transmitter Instruction Manual
IM08-MT-4E-TXRX-P1162
5
RADIO SERVICE SOFTWARE
PROGRAMMING
INTRODUCTION
NOTE: This manual contains general information about Radio Service Software (RSS). Software
revisions occur regularly. For current RSS versions and instructions, refer to up-to-date help
les on the Daniels Electronics website (www.danelec.com > Products > Software > Radio
Service Software (RSS) > RSS Download Page). Once RSS is downloaded with either the full
or demo version, click Help to access the help les.
Receiver and transmitter programming is performed with the PC-based RSS. A USB Type A to 5-pin
Mini-B cable (included with the software) is used to connect the USB port of an IBM-compatible
computer to the USB port on the front panel of the receiver or transmitter module.
The RSS allows the receiver or transmitter to be programmed for:
• operating frequencies
• CTCSS and DCS signaling
• P25 Digital settings, such as NAC and TGID
• modulation type
• many other parameters
System Recommendations:
• Microsoft Windows 2000
• Microsoft Windows XP
Recommended Minimum Specication:
• Pentium III Processor – 500 MHz
• 256 MB Memory (RAM)
• 1 GB Free Disk Space