User guide

Coda Audio DNC260
User Guide version 0.1 Page 16 of 30
Out1 Freq Width Gain
EQ1 100Hz 1.4Q 0.0dB
a
b
c
CHANNEL
EDIT
Pressing the edit navigation buttons gives access to the various pages of parameters
available for each channel. The currently selected page is shown in the bottom left hand
corner of the display. This is omitted on some pages where the function is obvious. The
screen shows up to three (normally related) parameters for a given part of the processing
functions on a given channel.
The edit buttons allow you to scroll, in either direction, through the different processing
pages for a given Channel. When you go past the last page, you will be returned to the
default page.
The channel buttons allow you to scroll, in either direction, through the input and output
channels, whilst trying to maintain the currently viewed processing block. If the channel
you scroll to does not have the currently viewed processing block, the next one will be
shown instead.
NB. When the unit powers-up, the settings will be the same as those when the unit was last
switched off.
Presets
The device contains a total of forty-five user and Factory Presets. The user cannot overwrite
the basic mono or basic stereo Preset programs.
Preset Recall
To select an existing preset, press the Recall Button so the indicator above it illuminates.
Turn parameter knob A until the required preset number is shown on the display. Factory
Presets are indicated by a box symbol appearing after the preset number. Press the Recall
Button again to activate the Preset. Pressing any other button will cancel the operation.