User guide

Coda Audio DNC260
User Guide version 0.1 Page 10 of 30
Front Panel
Input Signal Indicators
A set of three pairs of LEDs indicate signal present, +4dBu and input clip for each channel.
The signal present LEDs operate at approximately –40 dBu, giving a useful indication of
even relatively low input signal levels. The +4 dBu LEDs are intended to show nominal
operating level and can also be useful for setting system gain structure. Clip LEDs warn the
user of input overload and operate at +19 dBu.
Preset Store and Recall
These controls provide access to the 45 presets stored within the device. Pressing the store
button allows the user to name a preset and choose which memory location it will be held
in. Pressing store button again completes the process. The Recall function operates in a
similar way, pressing the recall button allows the user to select which preset they require,
pressing the button for a second time, then confirming, recalls the new DSP settings.
Note that presets cannot be stored or recalled when Secure mode is activated.
Channel Select Buttons
The currently selected channel is displayed on the top left hand corner of the LCD. Pressing
the channel buttons scrolls through the available input and output channels and finally
through the utility functions and back to the default screen. If operating a stereo linked
preset, the channel name will indicate the channel pairing. For example ‘A+B’ means both
input A and B parameters. The name of the output will be shown briefly at the top of the
display when stepping onto an output.
Store and
Recall buttons
Channel Select
buttons
2 x 24 chracter
LCD
Limiter
Indicators
Input Signal
Indicators
Edit Parameter
Select buttons
Parameter
Edit Encoders
Output Mute
buttons