User`s manual

UCR-4285 UNIVERSAL REMOTE CONTROL
14
• If your AV device does not have a power button, press the ‘Play’ button in step [13].
• Some TVs cannot be switched on with the ‘Power’ button. In that case, use a channel number button or
consult your TV manual for the correct manner to switch it on.
• If the product does not work or does not work properly:
- Check the correct placement and/or function of the batteries of the transmitter (replace if necessary).
- Check step by step whether everything is programmed properly.
- Some codes are very similar. Try another code in step [7] if some functions on the remote control
work and some do not.
- First press the correct device selection button before you operate the desired device.
- To control lighting: Make sure the house code set on the UCR-4285 is the same as the house code
on the COCO receiver you want to control (see [15] and table I). The number code of the receiver
must match the correct button on the UCR-4285 (see table II).
Dimmer function for lighting
• The dimmer function only works if the lamp is connected to a COCO dimmer receiver!
• If you want to control some of the receivers simultaneously (=program receivers to respond to the same
button on the remote control):
- Do not assign ‘dimmer receivers’ and ‘on/off receivers’ to the same button.
- Do not assign multiple ‘dimmer receivers’ to the same button.
Safety instructions
• Do not expose this product to excessive heat, direct sunlight or moisture.
• Remove the battery from the product if the product will not be used for an extended period.
• Do not attempt to repair this product. If the product is damaged or if you are in doubt about the proper
operation, take the product back to the place of purchase.
• Never use COCO products for life support systems or other applications in which equipment
malfunctions can have life-threatening consequences.
• Do not use the product in damp areas. Clean the device with a dry cloth.