User`s manual

UCR-4285 UNIVERSAL REMOTE CONTROL

• Programming a macro (example: Using the ‘Last’ button to switch from ‘TV’ mode to ‘SAT’ mode and

select channel 801):

1- Press ‘TV’ to select the mode in which you want to execute the macro.

2- Press and simultaneously. Do not release them until the indicator has flashed several times to

confirm.

3- Press ‘9 9 5’. The indicator flashes several times.

4- Press ‘Last’ to select the button you want to assign to the macro.

5- Now press the desired series of commands: ‘TV’, ‘AV’, ‘SAT’, ‘8 0 1’.

6- Press ‘Enter’ to save the macro, and don’t let go until the indicator flashes several times.

• Executing a saved macro: Press the button to which the macro is assigned for 1.5 seconds (in the

macro programmed above: ‘Last’).

• Cancelling a macro (example: the macro programmed above):

1- Press ‘TV’ to select the mode in which the macro was programmed.

2 Press and simultaneously. Do not release them until the indicator has flashed several times to

confirm.

3- Press ‘9 9 5’. The indicator flashes several times.

4- Press ‘Last’ to select the button assigned to the macro.

5- Press ‘Enter’. Do not release them until the indicator has flashed several times.

• A macro can contain a maximum of 32 pressed buttons.

• Assign a macro to a button you do not use, because the macro writes over the pre-programmed code.

• A macro can also be used to switch lights on and off (e.g. press a single button to switch off your Home

Theatre and switch on the lights near the TV).

• If a button on the original remote control must be held for several seconds to activate a particular

function, this function cannot be programmed in a macro.

Remarks

Reminders

• This product is a combination of an infrared remote control and a radio-frequency transmitter.

Remote control

: Controls numerous multimedia devices (TV, Stereo, DVD, MediaCenter PC etc.) in the

same manner as the original remote control.