User's Guide

Lights, beeps and buttons
Cochlear Limited 201156 323649 Iss 3 CP900 Series Sound Processors | User guides Cochlear Limited 2011 CP900 Series Sound Processors | User guides 57
Beep What it means
Short high beeps
Changing the program. The
number of beeps indicates the
number of the selected program.
High beep
Changing volume or sensitivity
level.
... Long high beep
Switching between using the
microphones and the telecoil or
audio accessory.
... ... Long low beeps
General fault.
Short low beep when you press a button
Processor buttons are locked.
Short low beeps
Processor battery is low.
Short low beeps
Battery is empty and processor
is turning off.
Beeps
Your clinician can set up your processor so you can hear the following beeps.
Flash of orange every second Coil is off, or processor is not
connected to the correct implant.
Quick fl ashes of orange
Processor battery is empty.
Steady orange General fault:
• Fault with processor
• Corrupt program
• Fault and coil off error at the same
time
• Fault with acoustic component
while in Hybrid mode.
Button controls in advanced mode
Sound processors can be set up in Advanced mode by your clinician to give you
extra control over the volume and sensitivity of the sound you hear.
Turn processor on and off
Press and hold upper and lower buttons
at the same time. Pressing and holding
the lower button will only turn on the
processor.
Press and hold the lower button.
Press and hold the upper button to
switch between microphones and
telecoil/audio accessory.
Change program
Turn telecoil/audio accessory on and off.