User's Manual

Tone What it means

.. .. You hear a

sequence of long low tones.

General fault.

You hear a short low tone

when you press a button.

Your processor buttons are locked.

You hear two short

low tones.

Your processor battery is low. You

need to replace the batteries, or

recharge the battery module.

You hear a sequence

of short low tones.

Your processor battery is empty.

You need to replace the batteries,

or recharge the battery module.

Using the telecoil

The telecoil is used to receive sound signals from a telephone,

roomloop, neckloop, etc. The telecoil can also receive sound signals

from an ampliﬁ er, TV or Hi-Fi through an induction loop.

To turn on the telecoil, press the upper button. A single long ﬂ ash of

green conﬁ rms that the telecoil is activated.

To turn off the telecoil, press the upper button again. A single long ﬂ ash

of green conﬁ rms that the telecoil is deactivated.

When an audio accessory is connected to your processor, you will not

receive any sound from the telecoil. To move back to using the telecoil,

remove the audio accessory from the processor.

Turn off the telecoil when not in use, as it reduces the microphone

volume.

Using Auto Telecoil

Your clinician can program your processor so that it automatically

turns on the telecoil when you use the telephone, or when you are in a

roomloop environment. The telecoil automatically turns off when:

You move the telephone away from your processor (e.g. when the •

telephone call ends).

You exit the roomloop environment.•

Using your processor

195992 Iss3 CP810 user guide 01.indd 33 13/05/2009 4:24:38 PM