User's Manual

Function Button press sequence

Adjust microphone volume or

sensitivity level.

Press the upper button to increase

volume or sensitivity level.

Press the lower button to decrease

volume or sensitivity level.

Discuss with your clinician which user interface would be more suitable

for you.

Checking the coil

The remote assistant has an in-built coil sensor that allows you to check

if the coil connected to your processor is receiving sound signals from

your processor.

To use the coil sensor:

Remove the coil from the head.1.

Place the coil on the coil sensor guides on the back of the remote 2.

assistant.

Figure 10: Placing the coil on the back of the remote assistant

If the coil is receiving sound signals, an animation will display on the

remote assistant display. This, however, only provides an indication and

does not conﬁ rm that the coil is functioning properly.

If the coil is not receiving sound signals, no response is displayed on the

display.

For more information, refer to the Remote Assistant User Guide.

Using your processor

195992 Iss3 CP810 user guide 01.indd 37 13/05/2009 4:24:38 PM