User's Manual

Failure from splashing water.•
When an audio accessory is attached, your processor is not protected
from dust and water damage.
To protect your processor from dust or water damage:
Ensure that microphone protectors are in place at all times.•
Ensure that the accessory socket cover is properly closed when you •
are not using an audio accessory.
Ensure that the coil cable plug seal is not damaged and that the •
coil cable plug is properly inserted into the processor coil cable
socket.
Always keep the coil cable plugged into the processor to prevent •
moisture getting into the coil cable socket. It is also important that
you keep the coil cable plugged into the coil.
If the battery contacts on the battery module become loose, •
contact your clinician as the connector between the processing
unit and the battery module could be broken.
Drying your processor
Remove your processor before applying cosmetics, skin care or hair
products. These substances can get into your processor and damage it.
If this happens, wipe the processor clean with a soft dry cloth.
Do not wear your processor while bathing, swimming or showering. If
the processor does get wet, dry the processor as follows:
Wipe your processor with a soft dry cloth. 1.
2. Place your processor in the Zephyr Dry & Store
®
for at least 12
hours.
56 - CP810 Sound Processor User Guide © Cochlear Limited 2009
Caring for your processor
195992 Iss3 CP810 user guide 01.indd 56 13/05/2009 4:25:34 PM