Operation Manual

6
9. Never operate the tiller with defective guards, covers or without safety devices in place.
10. Do not change the engine governor settings or over speed the engine.
11. Before starting the engine disengage the cultivator blade and drive clutches.
12. Keep your feet well away from the blade when starting the engine and in accordance with the
instructions.
13. Do not tilt the tiller when starting the engine and always start on a flat surface.
14. Never put hands or feet near or under rotating parts.
15. Always ensure the engine is fully switched off before picking up/carrying the tiller.
16. Stop the engine and disconnect the spark plug wire, make sure that all moving parts have come to
a complete stop and, where a key is fitted remove the key, make sure engine has had time to
cool.
- Before clearing the cultivator tines / blades
- Before checking, cleaning or working on the tiller.
- After striking a foreign object. Inspect the tiller for damage and make repairs before restarting.
- If the tiller starts to vibrate abnormally (check immediately).
17. Stop the engine and disconnect the spark plug wire, make sure that all moving parts have come to
a complete stop and, where a key is fitted remove the key, make sure engine is completely
cooled.
- Whenever you leave the tiller.
- Before refuelling.
18. Reduce the throttle setting during engine shut down and, if the engine is provided with a shut-off
valve, turn the fuel valve off.
Maintenance and Storage
1. Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
2. Never store the equipment with petrol in the tank inside a building where fuel vapours can reach an
open flame or spark or where the temperature is high.
3. Before storage allow the engine to cool.
4. To reduce the fire hazard, keep the engine, silencer, battery compartment and petrol storage area
free of grass, leaves, or excessive grease.
6. Replace worn or damaged parts for safety. Genuine parts should always be used as parts of
inferior quality can damage the equipment and compromise safety.
7. If the fuel tank has to be drained, this should be done outdoors. Always ensure engine is completely
cooled before starting this task.
8. If the cultivator blades/tines needs to be removed, wear strong gloves to prevent injury to hands
and fingers.
9. When transporting the machine make sure you close the fuel cut off. Be careful to ensure weight is
evenly distributed. Wear strong gloves.
10. When tilting the machine never tilt towards the air filter as this may become damaged with fuel.
11. Never crank the engine when the spark plug is removed.
12. Frequently check the fuel lines and fittings for damage and cracks, replace if necessary
13. Never start the engine with the air filter cover removed.
14. Carefully clean the tiller after use to remove debris as this can damage and corrode.
Warning: Do not touch rotating tines/blade.
Warning: Refuel in a well ventilated area with the engine stopped