Operation Manual

5.8 Assemble the depth regulator

5.8.1 Loosen the locking knob and then remove the depth regulator from the machine. (Fig. 11A)

5.8.2 Insert the depth regulator into the hole of the machine from bottom to top as show. (Fig. 11B)

5.8.3 Tighten the locking knob. (Fig. 11C)

Fig. 11A Fig. 11B Fig. 11C

5.9 Assemble the front wheel

5.9.1 Insert the drive-pipe into the hole of front wheel. (Fig. 12A/12B)

5.9.2 Fix the front wheel and wheel support with bolt and nut. (Fig. 12C/12D/12E)

Fig. 12A Fig. 12B Fig. 12C

Fig. 12D Fig. 12E

5.10 Assemble the Fender

5.10.1 Fix the fender into the unit body with screws. (Fig. 13A/13B)

5.10.2 Fix the other fender in the same way.

Locking knob

Drivepipe Drivepipe

Bolt

M10X75

Nut