Operation Manual

11
5.5.2 Tighten the nuts. (Fig. 6E)
Fig.6A Fig.6B Fig.6C
Fig.6D Fig.6E
5.5.3 Adjustment to the handle height
5.5.3.1 Move the handle up and down adjusted it to the proper height. There are 2 adjusting height to be
choose on this tiller; at 1 position, handle to the ground is highest, 2 position is the lowest.
5.5.3.2 Connect the handle and handle support with the 1 bolt, and 1 locking knob supplied as
Fig.7A Fig.7B Fig.7C
5.5.4 Attach the cable-clamp to the position shown and then attach the cable.
Fig.8A Fig.8B Fig.8C
Bolt M8X60
1
2
Cable clamp
Bolt M8X65