Troubleshooting guide

SPYBALL 6808-9/6828-9 ENGLISH 20
The turn indicators do not work - Is the diode installed the wrong
way round?
The alarm is not triggered when
the ignition is switched on
- Make sure that there is a 12V
positive supply when the ignition
is switched on to the ORANGE/n.
2 wire
- Try a substitute unit. If the
problem remains it is either an
installation problem or a problem
with the motorcycle
The alarm fuse blows every
time the system is armed
- Has the diode been installed?
- Check the earth connections
- Try a substitute unit. If the
problem remains it is either an
installation problem or a problem
with the motorcycle
The alarm/immobiliser is
disarmed, but the motorcycle
will not not start
(6828-9)
- Is the motorcycle in neutral gear?
- Is the kill switch in the RUN
position?
- Make sure that the main ignition
fuse in the motorcycle is intact
- Make sure that the motorcycle
battery is charged
- Some models will only start with
the side stand up or the clutch
lever pulled in
- Try a substitute unit. If the
problem remains it is either an
installation problem or a problem
with the motorcycle
The system is not triggered by
moving/lifting the bike
- Has the arming time elapsed?
- Is the movement sensor active
(not disabled)?
- Adjust the movement sensor (see
paragraph 4)