User`s manual

Setting Up - IBM Mainframe (zSeries)

40 AXIS 5570e / AXIS 5670e User’s Manual

Note:

Node Definitions The example below shows how the print server PU and LU definitions

may be coded in a local major node definition:

In the PU definition, IDNUM should be set to the five last digits of the Axis Network Print

Server node address, NODE_ADDR. By default NODE_ADDR stands for the five last digits of

the Axis Network Print Server serial number.

In the path definition,

PATH DIALNO should be comprised with its first two digits equal to

the place holder, the next two set to the SAP and the remaining twelve digits set to the Axis

Network Print Server Ethernet or Node address. By default the Ethernet/Node address is

identical to the Axis Network Print Server serial number. A valid

GRPNM must also be

supplied.

In the LU definition, the LOCADDR number maps to the Logical Printer number of the Axis

Network Print Server. The first eight Local Addresses pass the printout through Logical Printer

1-8. However, some IBM systems do not allow Local Address 1 to be used for printing. Refer

to “Logical Printers for Customized Printing” on page 154 for more information about

logical printers.

* 5570e DSPU DEFINITION

DSPU5570e5570e PU CUADDR=E31, X

MODETAB=MODE3290, X

PUTYPE=2,ISTATUS=ACTIVE,MAXBFRU=1

DSPULU02 LU LOCADDR=2 X

SSCPFM=USSSCS, X

USSTAB=USSTAB, X

PACING=1, X

VPACING=2, X

ISTATUS=ACTIVE, X

LOGAPPL=MWTC, X

DLOGMOD=SCS5570e