User`s manual

Setting Up - AS/400 (iSeries)
AXIS 5570e / AXIS 5670e User’s Manual 29
Verifying the
Communication Link
1. Type WRKCFGSTS *CTL xxxx* on the AS/400 command line (xxxx is the
first four characters of the Axis Network Print Server 5494 LU
Name)and press Enter. After a couple of minutes, ensure that the
following items are displayed:
• One APPC controller with the same name as the Axis Network Print
Server 5494 LU Name.
• One APPC device with the same name as the Axis Network Print
Server 5494 LU Name, one controller session
(QRMTWSC) and the
currently active printer sessions
(QRMTWSC).
• One twinax controller named xxxxxRMT, where xxxxx are the first
five characters of the Axis Network Print Server 5494 LU Name.
• One, two or three twinax printer devices named xxxxPRT0z (xxxx
are the first four characters of the Axis Network Print Server 5494
LU Name and z is the printer device number).
The status of all items should now be ACTIVE or VARIED ON.
2. Type
STRPRTWTR xxxxPRT0z on the AS/400 command line (xxxxPRT0z is
the printer device name) and press Enter. This command starts the writer
for this printer device.
3. Press the Axis Network Print Server test button once to print a test page.
Ensure that the SNA status is defined on the test page as
Idle, Actv or
LU-4.
TN5250E Printing (SCS over IP)
TN5250E is the recommended protocol to use when printing SCS data
streams over TCP/IP. This print method offers superior control,
management and throughput for the Axis Network Print Server.
Before you Begin Make sure that the AS/400 host is running OS/400 V3R2 or higher with
TCP/IP support installed and configured.
Make sure that the latest PTFs are installed. Information about which
PTFs to use can be obtained from:
The AS/400 Host
System Checklist
http://as400service.rochester.ibm.com/
There is an AS/400 Parameter checklist in the AXIS 5570e/AXIS 5670e Axis Network Print
Server User’s Guide where you can enter the values described in this section for future
reference.