User`s manual

Setting Up - AS/400 (iSeries)
26 AXIS 5570e / AXIS 5670e User’s Manual
8. Type DSPSYSVAL QAUTOCFG on the command line and press Enter. Make sure
the
Autoconfigure device parameter is turned on (1). Press F3 to exit.
9. Type
DSPSYSVAL QAUTORMT on a command line and press Enter. Make sure
the Autoconfigure remote controller parameter is turned
on(1). Press F3 to exit.
10. Type
DSPMODD QRMTWSC on the command line and press Enter. Press F11 to
display the keywords. Verify that the mode description exists on the system
and that it is configured as presented in the example below. Use the
command
WRKMODD QRMTWSC if you need to change a value.
Press F3.
Display System Value
System value . . . . . : QAUTOCFG
Description . . . . . : Autoconfigure devices
Autoconfigure device . : 1 0=Off
1=On
Display System Value
System value . . . . . : QAUTORMT
Description . . . . . : Autoconfigure of remote controllers
Autoconfigure remote controller : 1 0=Off
1=On
Display Mode Description S44A6643
Mode description . . . . . . . :MODD QRMTWSC
Class-of-service . . . . . . . :COS #CONNECT
Maximum sessions . . . . . . . :MAXSSN 57
Maximum conversations. . . . . :MAXCNV 57
Locally controlled sessions. . :LCLCTLSSN 56
Pre-established sessions. . . .:PREESTSSN 0
Maximum inbound pacing value. .:MAXINPAC *CALC
Inbound pacing value . . . . . :INPACING 7
Outbound pacing value . . . . :OUTPACING 7
Maximum length of request unit.:MAXLENRU *CALC
Data comp
r
ession . . . . . . . :DTACPR *NETATR
Inbound data compression . . . :INDTACPR *RLE
Outbound data compression . . :OUTDTACPR *RLE
Session level encryption . . . :SLE *NONE
Text . . . . . . . . . . . . . :TEXT This Mode
is IBM Supplied
Press Enter to continue. Bottom
F3= Exit F11=Nondisplay keywords F12=Cancel