Owner's Manual

3. Fit the upper handle
Fit the upper handle section with the ratchet fixing bolt and the handle bar lock lever as shown above.
4. Adjustment of the drum brake cable
1. Install brake cable. Remove front jam nut and insert cable stop into brake lever.
2. Once inserted, pull cable back and insert into cable mount. Thread outer nut back on leaving about 15mm of
thread showing. Using 13mm spanner to tighten both jam nuts.
3. Adjustment can be done with the knob on the end of the brake handle. Turing the knob clockwise will
increase tension. Counter-clockwise will release the tension.
4. Always check the brake operates as expected before use.