Owner's Manual
Table Of Contents
- Owner's Manual
- CONTENTS
- INTRODUCTION
- SC 200 DASH CAM FEATURES
- PRODUCT SERVICE AND SUPPORT
- WHAT’S IN THE BOX
- HARDWARE INTERFACE
- INSTALLATION
- BASIC OPERATION
- INITIAL SETUP
- VIDEO SCREEN
- VIDEO SETTINGS
- VIDEO AND PHOTO PLAYBACK MODE
- VOICE ANNOUNCEMENTS
- VOICE COMMANDS
- MEMORY CARD STORAGE
- SAFETY FEATURES
- GENERAL SETTINGS
- FIRMWARE UPDATES
- CAMERA SPECIFICATIONS
- TROUBLESHOOTING
- FAQ
- TRADEMARKS ACKNOWLEDGEMENT, WARNINGS, and REGULATORY INFORMATION
- Quick Start Guide
- Product Info
- lmportant Product lnformation
Regulatory
Information
NOTE: This
device
complies
with
part
15
of
FCC rules:
Operation
is
subject
to
the
followi
ng
two
conditions:
(1)
This device
may
not
cause harmful interference,
and
(2)
This
device
must
accept any interference received
including
interference
that
may cause undesired
operation.
This
equipment
has
been
tested
and
found
to
comply
with
the
li
mits
for
a
Class B
digital
device,
pursuant
to
Part 15
of
the
FCC Rules.
These
limits
are
designed
to
provide
reasonable
protection
against
harmful
interference
in
a
residential
installation.
This
equipment
generates,
uses
and
can
radiate
radio
frequency
energy
and,
if
not
installed
and
used
in
accordance
with
the
instructions,
may
cause
harmful
interference
to
radio
communications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in a
particular
installation.
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the
following
measures:
Reorient
or
relocate
the
receiving
antenna.
Increase
the
separation
between
the
equipment
and
receiver.
Connect
the
equipment
into
an
outlet
on
a
circuit
different
from
that
to
which
the
receiver
is
connected.
Consult
the
dealer
or
an
experienced
radio/TV
technician
for
help.
CAUTION:
Modifications
or
parts
not
approved
by
Cobra Electronics
Corporation
may
violate FCC Rules and
void
authority
to
operate
this
equipment.
This device
complies
with
RSS-310
of
Industry Canada.
Operation
is
subject
to
the
condition
that
this
device
does
not
cause harmful interference.
RF
Exposure
FCC
RF
Radiation Exposure Statement:
1.
This Transmitter
must
not
be
co-located or operating
in
conjunction
with any
other
antenna or transmitter.
2.
This
equipment
complies with
RF
radiation
exposure
limits
set
forth for
an
uncontrolled environment.
3.
This
equipment
should
be
installed
and
operated
with minimum
distance
20cm
between
the
device
&
your
body.
The device has
been
tested
and
compliance with SAR limits, users can obtain
Canadian information
on
RF
exposure
and
compliance.
Le
present
appareil
est
conforme Apres
examen
de
ce
materiel aux conformite
aux limites DAS
etlou
aux limites d'intensite
de
champ
RF,
/es utilisateurs
peuvent
sur /'exposition aux radiofrequences
et
la
conformite
and
compliance
d'acquerir
Jes
informations correspondantes.