Operation Manual
3. AFTER USE
1). Switch the product off, disconnect it from the power
supply and let it cool down.
2). Check, clean and store the product as described below.
4. GRASS CATCHER
1). Inspect the grass catcher (15) before each use. Do not
use it if you find any damage.
2). Clean the grass catcher (15) after operation. Let the
grass catcher dry thoroughly before storing to avoid mildew.
5. TRANSPORTATION
1). Switch the product off and disconnect it from the power
supply before transporting it anywhere.
2). Attach transportation guards, if applicable.
3). Adjust the cutting depth to the transportation setting (refer
to “CUTTING DEPTH ADJUSTMENT”).
4). Always transport the product using its handle.
5). Protect the product from any heavy impact or strong vibrations
which may occur during transportation in vehicles.
6). Secure the product to prevent it from slipping or falling
over.
TROUBLESHOOTING
WARNING! Only perform the steps described in these instructions! All further inspection,
maintenance and repair work must be performed by an authorised service specialist! Contact
your local authorised service dealer if the problem cannot be solved by yourself!
WARNING! If the pr
oduct does not perform properly, makes unusual sounds, the motor
does not start or stop as described, the cutting device does not work properly, or any other
irregularity or malfunction occurs, do not attempt to repair the product by yourself. Please
contact customer services or your local authorised service dealer.
Problem
Possible cause
Fault correction
Product does not start
Not connected to power supply
Connect to power supply
Power cord or plug is defective
Check by a specialist electrician.
Other electrical defect to the
product
Check by a specialist electrician.
Lock-off button not pressed
Press lock-off button first, then
the start/stop lever
Product does not reach
full power
Power source’s (e.g. generator)
voltage is too low
Connect to another power source
Air vents are blocked
Clean the air vents
Poor results
Cutting device is dull/damaged
Replace with a new one
Scarified material exceeds
capacity
Only scarify materials according
to the capacity of the product
Scarifying depth is incorrect
Adjust depth
26/02/2013 v1
21