Operation Manual

Fig. 11a
raking cylinder with fine needles
Fig. 11b
2. REPL
ACING/CHANGING THE CUTTING DEVICE
WARNING! Always switch the product off,
disconnect it from power supply and let it cool down
before changing/replacing the cutting device!
WARNING! Always use the correct cutting device
according to the intended use! Observe the technical
requirements of this product (see the Technical specifications
section) when purchasing and using cutting devices!
Cutting devices are very sharp and become hot
during use! Handle them carefully!
Wear safety gloves when handling cutting devices in order to
avoid injuries like burns and cuts!
WARNING! Make sure the two bolts are completely
tight before using the product, don't use the product
if any of the bolts are missing or loose.
If a bolt thread is damaged, it must be replaced before the
machine can be used safely. You can replace it with one of a
suitable size.
The product has two functions, scarifying or raking. The
scarifying cylinder is preassembled on the product. The
raking cylinder is included in the supply box. The cylinder
can be changed a
ccording to the different applications. (See Fig.
11a, 11b)
1). Rem
ove the grass catcher.
2). Place the product upside down on a flat stable ground to
access the underbody.
3). Loosen the two bolts (22a) with a suitable wrench,
remove them together with the spring washers (22b) and
the attached cutting device (21 or 23). (See Fig. 12a).
4). To remove the cutting device, first lift the bearing and
then pull it off of the drive shaft (25).
Fig. 12a
Fig. 12b
5). Alig
n and insert the respective cutting device: Slide
the hex nut into the socket of the driving shaft (25) and fix
the bearing to the support with the bolts (22a) and spring
washers (22b). (See Fig. 12b).
26/02/2013 v1
20
scarifying cylinder with blades
22a
22b