Operation Manual
7. OVERLOAD PROTECTION
The overload protection will be activated in the following
circumstances:
1). A build up of scarified material around the cutting device.
2). If the material scarified is too large and causes the motor
to work beyond its capacity.
3). Where there is too much resistance against the cutting
device.
When the circuit breaker has been activated switch off the
product and disconnect from the power supply.
Let the product cool down and eliminate the cause of the
overload before using the product again.
8. GENERAL OPERATION
WARNING! In some countries regulations define
at what time of the day and on what days machines
are allowed to be used and what restrictions apply!
WARNING! If the product strikes a foreign object
stop the motor! Switch the product off, disconnect it
from the power supply and let it cool down. Inspect the
product thoroughly for damage! Have any damage repaired
before restarting!
WARNING! If the machine vibrates unusually
during operation is may indicate that it is damaged!
The product should be inspected and repaired immediately!
1). Check the product, its power cord and plug as well as
accessories for damage before each use. Do not use the
product if it is damaged or shows wear.
2). Double c
heck that accessories are properly connected.
3). Push the product forward by its handle. Keep the handle
dry to ensure safe support.
4). Ensure that the air vents are always unobstructed and
clear. Clean them if necessary with a soft brush. Blocked air
vents may lead to overheating and damage the product.
5). Switch the product off immediately if you are disturbed
while working by other people entering the working area.
Always let the product come to complete stop before
releasing the handles.
6). Do not overwork yourself. Take regular breaks to ensure
you can concentrate on the work and have full control over
the product.
7). Mow the lawn before working and fertilise afterwards.
8). Make sure that the lawn is clear of stones, sticks, wire or
other objects that could damage the product or its motor.
26/02/2013 v1
17