Owner's Manual

Set CTCSS Privacy Codes
To select a CTCSS privacy code:
1. During Standby mode, press and release the
Power/Menu button to select a desired channel.
2. Within 5 seconds, press and hold the Function button
until the current code number prompted. The
following messages may be prompted:
a. “Channel Code Memory” means the current
channel is still preset with default privacy code
system and code number. See Channel and
Default Privacy Code Table on page 10, or
b. The current CTCSS Code Number, or
c. “Code Off” means no privacy code is set on the
current channel, and allows all signals to be heard
on a channel.
3. After the current code number prompted, press the Up or Down button to
select CTCSS code number; Or press and hold the Up or Down button for
fast skipping.
4. When the desired CTCSS code number selected, choose one of the
following.
a. Press the Up or Down button to change a new CTCSS code number.
b. Press the Talk button to enter the new setting and return to Standby
mode.
c. Press the Menu button to enter the new setting and return to Channel
Selection mode.
d. Do not press any buttons for 6 seconds to enter the new setting, the
current channel number and privacy code setting (if any) prompted
again, and then return to Standby mode.
Power/Menu button
Function Button
Up(+)/Down(-)
Buttons
Privacy Codes
Your radio incorporates two advanced coded squelch systems that can help to
reduce interference from other users on any given channel. CTCSS (Continuous
Tone Coded Squelch System) provides 38 privacy codes and DCS (Digitally
Coded Squelch) provides privacy codes for factory default channel preset. The
CTCSS (Continuous Tone Coded Squelch System) can be used on all channels.
For ease of use and to reduce interference from other users, the 22 channels
of your radio have been customized, see Channel and Default Privacy Code
Table.
10 11
The privacy code OFF is not a privacy code, but allows all signals
to be heard on a channel that is set to 0 on both the CTCSS and
DCS systems.
See Page 12 for resetting all the channels and privacy code
setting to factory default.
You can change your radio Privacy Codes in order to work with
other radios with different privacy codes or radio without
privacy codes. See page 11 and 12 for procedures.
To successfully communicate using a privacy code, both the
sending and receiving radios must be tuned to the same channel
and to the same privacy code number (CTCSS or DCS). Each
channel will remember the last privacy code system and number
you select.
Channel and Default Privacy Code Table
Channel
Privacy Code
Type Number
1 CTCSS 1
2 CTCSS 11
3 CTCSS 22
4 CTCSS 33
5 DCS 1
6 DCS 11
7 DCS 22
8 DCS 33
9 DCS 44
10 DCS 55
11 DCS 66
Channel
Privacy Code
Type Number
12 DCS 77
13 CTCSS 1
14 CTCSS 11
15 CTCSS 22
16 CTCSS 33
17 DCS 1
18 DCS 11
19 DCS 22
20 DCS 33
21 DCS 44
22 DCS 55