Owner's Manual

Standby Mode
When Battery low
When you press and
hold Talk button and
the Radio is
transmitting
During VOX feature
enabled
Power Off the Radio during charging
Under Charging
Fully Charge
LED indicators
2
Caring for Your microTALK
®
Radio
Your microTALK
®
radio will give you years of trouble-free service if cared for
properly. Handle the radio gently. Keep the radio away from dust. Never put
the radio in water or in a damp place. Avoid exposure to extreme
temperatures.
Installing Batteries (Battery already pre-installed)
To install or replace batteries:
1. Remove Holster by releasing the belt clip latch and
slide the holster downward.
2. Unscrew 2 screws at battery door with a proper
screwdriver, you may use a Philips* Head #1
screwdriver to open it.
3. Open the battery compartment cover, connect the
connector of the battery to the socket of the radio
inside the battery compartment in proper polarity.
4. Place the battery inside battery compartment and
align the wires as shown.
(Note: Wires are required to be tucked into the battery
compartment completely and carefully. If any object
interfere the O-ring, its sealing performance will be
affected.)
5. Place the battery compartment cover, screw down the
screws mildly.
(Screw nuts may be damaged if overtighten)
6. Re-attach the holster.
3
Maximum range may vary and is based on unobstructed
line-of-sight communication under ideal conditions.
Remove Screws
1
2
Remove Holster
Features
• 22 Channels with
Preset privacy
codes
• User Adjustable
Privacy Codes (38
CTCSS codes)
• Hands-Free
Operation (VOX)
• Speaker/
Microphone Jack
• Roger Beep
Selectable On/Off
• Battery/Power
Saver
• Keystroke Tones
• Low Battery
Audible Alert
• Auto Squelch
• Holster with Swivel
Clip
• IP54 Dust
Protected and
Water Resistant
O-ring
Wires Alignment
1
2
Battery Connector
Green LED ashes
every 5 seconds
Red LED ashes every
5 seconds
Green LED on
Blue LED ashes every
5 seconds
Solid Red (No ash)
Solid Green (No ash)