King Cobra® 1200 Pro INFORMATION AND OPERATING INSTRUCTIONS TABLE OF CONTENTS Introduction Important Safety Instructions Know Your Machine Control Panel Set-Up and Operation 1200PSI High Pressure Washer 500PSI and Heat Auto-Fill Auto-Dump After Use After Using the Machine
IMPORTANT SAFETY INSTRUCTIONS: To reduce the risk of fire, electric shock, or injury: • • • • • • • • • • • • • • • • • • • • Before each use, remove the spray tool from the hose, and check to make sure the spray nozzles are securely tightened to the spray tool. A loose nozzle could fly off during use. Never use solvents. Do not leave the machine unattended when it is plugged in. Unplug the unit from the outlet when not in use, and before servicing. To avoid electric shock, do not expose to rain or snow.
INSTRUCTIONS FOR USE KNOW YOUR MACHINE 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 Vacuum Hose Connection Recovery Tank Lid Wand Holder Control Panel Recovery Tank 1200PSI Quick Connect Auto-Fill Hose Connector Rear Wheel Base Compartment 500PSI Quick Connect 1200PSI Gauge 500PSI Gauge 500PSI Pressure Adjust Knob Holding Tank Tank Latch Vacuum Hose Reel Recovery Tank Drain Hose Dump Hose Connection Power Cord Receptacle Power Prime Pedal Front Castor with Brake Power Cord
CONTROL PANEL A Separate Circuit Locator Light: This green light will turn on when the two power cords are plugged into separate circuits. Try different outlets with one cord until you can get a green light, otherwise a circuit breaker in the wall may trip. B High Pressure/Heat Switch: This selector switch determines whether you will use the 1200 psi pump or the heater. You can select either, but not both at the same time. The heater will only work with the 500 psi pump.
SET-UP AND OPERATION 1200PSI HIGH PRESSURE WASHER CAUTION! Use care when handling hazardous chemicals. Never leave the machine running when you are not actively using it. Always use a defoamer when foaming occurs to prevent vacuum motor damage. DANGER! Do NOT use solvents, or any chemicals that may be flammable, explosive or combustible. CLEANING SOLUTIONS: Select a proper pre-spray for the surface to be cleaned, and apply the pre-spray.
SET-UP AND OPERATION 500PSI AND HEAT CAUTION! Use care when handling hazardous chemicals. Never leave the machine running when you are not actively using it. Always use a defoamer when foaming occurs to prevent vacuum motor damage. DANGER! Do NOT use solvents, or any chemicals that may be flammable, explosive or combustible. CLEANING SOLUTIONS: Select a proper pre-spray for the surface to be cleaned, and apply the pre-spray.
INSTRUCTIONS FOR USE ENGLISH - A SET-UP AND OPERATION 500PSI AND HEAT A B D F 28 1 2 17 22 6 7 12 24 13 23 10
AUTO-FILL OPERATION: • • • • Attach a 3/4” garden hose to the Auto-Fill Hose Connector (7), and connect the other end of the hose to your water source. Make sure the float that hangs from the auto fill valve into the tank is free of obstruction and can move freely. Turn on the water supply. NOTE: Do not turn the water pressure on high; just turn the water on.
POWER CORD MAINTENANCE Once a week (or more often if necessary), check the power cords for cracked or damaged insulation, exposed wires in the cord or plug, and damaged or missing ground pin. Repair or replace damaged cord or plug immediately. MAINTENANCE: For optimum performance, flush the machine with clear water at the end of each working day. Once a month, minimum, run a flushing compound through the machine to break up any mineral or chemical build-up that may have formed.
