Specifications

41
Instructional Procedures for Installation
of the EAGLE 6 in 1 machine.
This unit should be installed only by those who have been trained and delegated to do so and
who have read and understand both the operators’ manual and the installation manual. Failure to
follow the instructions, procedures, and safety precautions in this manual may result in acci-
dents and injuries.
Install, use, and operate this unit only in full compliance with all pertinent O.S.H.A. requirements
and all pertinent Federal, State, and Local codes or requirements and with BOSS INDUSTRIES,
Inc. instructions.
Do not modify this compressor except with written factory approval.
1. MOUNTING COMPRESSOR
When mounting the compressor care should be taken to ensure that its location does not im-
pede the operation of other components on the vehicle. For example, if your vehicle is equipped
with a crane, you must make sure the compressor will not interfere with the swing of the crane.
In addition, the compressor should be installed in an area that permits cool ambient air to enter
the air filter and the hot air from the cooler to exhaust without recirculating into the air filter. One
last consideration in the mounting should be the routing of hoses and electrical wires. The frame
mounting holes are shown below and the unit should be secured to the flat skid with 3/8 inch
grade 8 bolts, washers should be used on the mounting surface.