Operation Manual

- 17 -
12 TROUBLES SHOOTING
PROBLEM PROBABLE CAUSE CORRECTIVE ACTION
Engine does not
start.
Instart battery is not charged Charge the battery with the charger
Fuel tank is empty. Fill tank with fuel: refer to ENGINE OWNERS MANUAL.
Air cleaner element is dirty. Replace the air cleaner element: refer to ENGINE OWNERS
MANUAL
Spark plug loose. Tighten spark plug to 25-30 Nm.
Spark plug wire loose or
disconnected from plug.
Install spark plug wire on spark plug.
Spark plug gap is incorrect. Set gap between electrodes at 0.7 to 0.8mm
Spark plug is defective Install new, correctly gapped plug: refer to ENGINE OWNERS
MANUAL
Carburetor is flooded with fuel Remove air cleaner element and pull starter rope continuously
until carburetor clears itself and install air cleaner element.
Faulty ignition module Contact the service agent.
Engine difficult to
start or loses
power.
Dirt, water, or stale fuel tank. Drain fuel and clean tank. Fill tank with clean, fresh fuel
Vent hole in fuel tank cap is
plugged.
Clean or replace fuel tank cap.
Air cleaner element is dirty. Clean air cleaner element.
Engine operates
erratically.
Spark plug is defective. Install new, correctly gapped plug: refer to ENGINE OWNERS
MANUAL
Spark plug gap is incorrect. Set gap between electrodes at 0.7 to 0.8mm
Air cleaner element is dirty. Clean air cleaner element: refer to ENGINE OWNERS MANUAL
Engine idles
poorly.
Air cleaner element is dirty. Clean air cleaner element: refer to ENGINE OWNERS MANUAL
Air slots in engine shroud are
blocked.
Remove debris from slots.
Cooling fins and air passages
under engine blower housing are
blocked.
Remove debris from cooling fins and air passages.
Engine skips at
high speed.
Gap between electrodes of spark
plug is too close.
Set gap between electrodes at 0.7 to 0.8mm
Engine overheats Cooling air flow is restricted. Remover any debris from slots in shroud, blower housing, air
passages
Incorrect spark plug. Refer to the engine manual
Mower vibrates
abnormally
Cutting assembly is loose. Tighten blade
Cutting assembly is unbalanced Balance blade.