Operation Manual

- 7 -
(According to 2000/14/EC)
Vibration
(According to EN 836 Annex G)
2.168m/s²
k=1.5m/s²
5. ASSEMBLY
5.1 FOLDING HANDLE
For the MX46SPH
1. Fix the lower handlebars into the mower body with the locking knobs, bolts and washers as Fig. 1A,/Fig.1B/Fig.1C shown.
2. Lift the two locking levers to release the upper handlebars for folding. (Fig.1D)
3. Push the locking lever closed to lock the handlebars in the operating position. (Fig. 1E)
4. Adjust the tension by turning the lock nut with a suitable spanner. (Fig.1F)
5. Attach the cable-clamp to the position shown and then attach the cable. (Fig.1G/Fig.1H)
Fig.1A Fig.1B Fig.1C
Fig.1D Fig.1E Fig.1F
Fig.1G Fig.1H
5.2 ADJUSTMENT FOR AN APPROPRIATE ANGLE
For MX46SPH
A).Pull the locking lever open on both sides of the handle.
B).Adjust the angle of the handle by raising or lowering as required. The angle can be adjusted by -20º to 20º as the Fig.2 shows
C).Push the locking lever closed to connect the lower handle and the upper handle.