Operation Manual

- 16 -
14. TROUBLE SHOOTING
Fault Remedial action
Motor does not run
check mains connection cable
Start on short grass or on an area which has already been mown.
Clean discharge channel/housing –the mowing blade must rotate
freely. Disconnect the power supply first.
Correct the cutting height.
Motor power drops
Raise the cutting height, in long grass.
Clean discharge channel/housing.
Check the cutting blade’s sharpness, replace as necessary.
Grass catcher is not filled
Very long grass may require a higher cutting height.
Wet grass is more prone to clogging - allow the lawn to dry
Check the cutting blade’s sharpness, replace as necessary.
Clean the grille and fabric of the grass catcher, to improve air flow.
Clean the discharge channel / housing – Disconnect the power first.
Wheel drive does not function
Adjust the flexible cable.
Check the V-belt / gears – refer to your local service centre.
Check the drive wheels for damage.
Warning: before performing any maintenance or cleaning work, always pull out the mains plug and
wait until the cutter has come to a standstill.
CAUTION! Faults which can not be rectified with the aid of this table may be rectified by a Cobra
Service Centre only.