Operation Manual

- 9 -
5.5 HEIGHT OF CUT
Apply outward pressure to disengage lever from the rack. Move lever forward or back to adjust height. (Fig.6 and see 7.9)
Fig. 6
5.6 Tool Box
This type of lawn mower has a tool box, you can push the button to open it, and then press the cover to lock it. You can put tools
such as spanner, screwdriver in these boxes. (Fig. 6.1)
Fig. 6.1
6. “3 IN 1”
The lawn mower has 3 in 1 features:
1. Rear grass collection.
2. Grass mulching.
3. Side-discharge.
What is mulching?
When mulching, the grass is cut in one working stage, then finely chopped and returned to the grass strip as natural fertilizer.
Recommendations for mulch-mowing:
- Cut your lawn regularly. Cut-back by a maximum of 2cm from grass of 6cm height.
- Ensure the blade is sharp for best results - Do not mulch wet grass.
- Set maximum engine speed.
- Only move at a walking pace.
- Regularly clean mulching wedge, housing inner side and mowing blade.
Starting Operation
ONE: Retrofitting for mulching mower
WARNING: only change with a stopped motor and standstill cutter.
1. Raise the rear cover and remove the grass catcher.
2. Push the mulching wedge into the deck. Lock the mulching wedge with the button into the opening on the deck. (Fig 7A/Fig 7B)
3. Lower the rear cover again. (Fig.7C)