Operation Manual

- 13 -
make sure they are dry and are not laying too thick on the lawn. Do not wait for all the leaves to be off the trees before you mow.
WARNING: if the mower blade strikes a foreign object, then stop the engine. Remove the wire from spark plug, thoroughly
inspect the mower for any damage and repair the damage before restarting and operating the mower. Extensive vibration of the
mower during operation is an indication of serious damage. The unit should be promptly inspected and repaired.
7.7 GRASS CATCHER
There is a level indicator on the top of the grass catcher that shows whether the catcher is empty or full:
- The level indicator inflates if the catcher is not full during mowing. (Fig. 12B)
- If the catcher is full, the indicator collapses; once this happens, stop mowing immediately and empty the catcher, make sure it is
clean and ensure its meshwork is ventilated. (Fig. 12A)
IMPORTANT:
If the position of indicator opening is very dirty, the indicator will not inflate-in this case, clean the position of indicator opening
immediately.
Fig. 12A Fig. 12B
7.8 DECK
The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings, leaves, dirt or other
matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent proper mulching. The deck may be
cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug wire is disconnected).
7.9 HEIGHT ADJUSTMENT INSTRUCTIONS
CAUTION: Do not at any time make any adjustment to lawnmower without first stopping the engine and disconnecting the
spark plug wire.
CAUTION: before changing mowing height, stop mower and disconnect spark plug cable.
Your mower is equipped with a central height adjustment lever offering 7 height positions.
The height (the blade to the ground) can be adjusted from 25mm to 75mm (7 height positions). (Fig.13)
1. Stop mower and disconnect spark plug cable before changing mower cutting height.
2. The central height adjustment lever offers you 7 different height positions.
To change the height of cut, squeeze adjuster lever toward the wheel, moving up or down to selected height.