Operation Manual

9
Recommendations for mulch-mowing:
- Cut your lawn regularly. Cut-back by a maximum of 2cm from grass of 6cm height.
- Ensure the blade is sharp for best results - Do not mulch wet grass.
- Set maximum engine speed.
- Only move at a walking pace.
- Regularly clean mulching wedge, housing inner side and mowing blade.
Starting Operation
ONE: Retrofitting for mulching mower
1. Raise the rear cover and remove the grass catcher.
2. Push the mulching wedge into the deck. Lock the mulching wedge with the button into the opening on the deck.
(Fig. 7A/Fig. 7B)
3. Lower the rear cover again.
WARNING: only with a stopped motor and standstill cutter.
Fig. 7A Fig. 7B
TWO: Resetting for side discharge mowing
1. Lift the rear cover and remove the grass catcher.
2. Mount the mulching wedge.
3. Lift the sideward flap for side discharge. (Fig. 8A)
4. Mount the discharge guide for side discharge on the support pin of the sideward flap. (Fig. 8B)
5. Lower the sideward flap- the flap lies on the discharge channel. (Fig. 8C)
WARNING: only when the engine and cutting are at standstill.
Fig. 8A Fig. 8B