Operation Manual

- 9 -
5.2 ADJUSTMENT FOR AN APPROPRIATE ANGLE
For MX51SPH
A).Pull the locking lever open on both sides of the handle.
B).Adjust the angle of the handle by raising or lowering as required. The angle can be adjusted by -20º to 20º as the Fig.2 shows
C).Push the locking lever closed to connect the lower handle and the upper handle.
Fig.2
5.3 MOUNTING AND DISMOUNTING THE GRASS CATCHER
1. To fit: Raise the rear cover and hitch the grass catcher on rear of the mower.
2. To remove: grasp and lift the rear cover, remove grass catcher.
Fig.3A Fig.3B Fig.3C
5.4 STARTER HANDLE
Move the starter handle from the engine to the rope guide. (Fig.4A, 4B)
Fig. 4A MX51SPH Fig.4B M51SPH
5.5 HEIGHT OF CUT
Apply outward pressure to disengage the lever from the rack. Move lever forward or back to adjust the height. (Fig.5A/B see
clause 7.9) Fig. 5A MX51SPH Fig.5B M51SPH