Operation Manual

- 15 -
For the M51SPH
Your mower is equipped with a central height adjustment lever offering 10 height positions.
The height (the blade to the ground) can be adjusted from 25 mm (position 1) to 70 mm (position 10).
Fig.12A Fig.12B
1. Stop the mower and disconnect the spark plug cable before changing the mower cutting height.
2. The central height adjustment lever offers you 10 different height positions.
3. To change the height of cut, squeeze the adjuster lever towards the wheel, moving up or down to the required height. (Fig.12B)
8. MAINTENANCE INSTRUCTIONS
SPARK PLUG
Use only the original replacement spark plug. For best results, replace the spark plug every 100 hours of use.
9. LUBRICATION INSTRUCTIONS
CAUTION: DISCONNECT THE SPARK PLUG BEFORE SERVICING.
. 1. WHEELS-Lubricate the ball bearings in each wheel at least once a season with a light oil.
2. ENGINE-Follow engine manual for lubrication instructions
10. CLEANING
CAUTION: Do not hose the engine. Water can damage the engine or contaminate the fuel system.
1. Wipe the deck with a dry cloth.
2. Hose under the deck by tilting the mower so that the spark plug is up.
10.1 ENGINE AIR FILTER
CAUTION: Do not allow dirt or dust to clog the air filter foam element.
The engine air cleaner element must be serviced (cleaned) after 25 hours normal mowing. The foam element must be serviced
regularly if the mower is used in dry dusty conditions.
TO CLEAN THE AIR FILTER
CAUTION: Do not allow dirt or dust to clog the air filter foam element. The engine air cleaner element must be serviced (cleaned)
after 25 hours of normal mowing. The foam element must be serviced more regularly if the mower is used in dry dusty conditions.
TO CLEAN THE AIR FILTER
1.1 Remove the locking knob.( Fig.13A)
2. Remove the filter cover.
3. Wash filter element in soap and water. DO NOT USE PETROL!
4. Air dry the filter element.
5. Place a few drops of SAE30 oil on the foam filter and squeeze tightly to remove any excess oil.
6. Reinstall the filter.