Operation Manual

- 14 -
will also help to clean up any stray clippings left on the lawn.
The mower should always be operated at full throttle to get the best cut and allow it to do the most effective job of mowing.
Clean underside of deck: Be certain to clean the underside of the cutting deck after each use to avoid a build-up of grass, which
could prevent proper mulching.
WARNING: If the mower blade strikes a foreign object, stop the engine immediately. Remove the wire from the spark
plug, thoroughly inspect the mower for any damage and repair the damage before restarting and operating the mower. Extensive
vibration of the mower during operation is an indication of serious damage. The unit should be promptly inspected and repaired
7.7 GRASS CATCHER
There is a level indicator on the top of the grass catcher that shows whether the catcher is empty or full:
- The level indicator inflates if the catcher is not full during mowing. (Fig. 11B)
- If the catcher is full, the indicator collapses; once this happens, stop mowing immediately and empty the catcher, make sure it is
clean and ensure its meshwork is ventilated. (Fig. 11A)
IMPORTANT:
If the position of indicator opening is very dirty, the indicator will not inflate-in this case, clean the position of indicator opening
immediately.
Fig. 11A Fig. 11B
7.8 DECK
The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings, leaves, dirt or other
matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent proper mulching. The deck may be
cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug wire is disconnected).
7.9 HEIGHT ADJUSTMENT INSTRUCTIONS
CAUTION: Do not at any time make any adjustment to the lawnmower without first stopping the engine and disconnecting
the spark plug wire.
CAUTION: before changing the mowing height, stop the mower and disconnect the spark plug cable.
For the MX51SPH
Your mower is equipped with a central height adjustment lever offering 7 height positions.
The height (the blade to the ground) can be adjusted from 25 mm (position 1) to 75 mm (position 7).
1. Stop the mower and disconnect the spark plug cable before changing the mower cutting height.
2. The central height adjustment lever offers you 7 different height positions.
3. To change the height of cut, squeeze the adjuster lever towards the wheel, moving up or down to the required height. (Fig.12A)