Operation Manual

WARNING: never fill fuel tank indoors, with the engine running or until the engine has been allowed to cool for at least 15

minutes after running.

7.2 TO START THE ENGINE AND ENGAGE THE BLADE

1. The unit is equipped with a rubber boot over the end of the spark plug, make certain the metal loop on the end of the spark plug

wire (inside the rubber boot) is fastened securely over the metal tip on the spark plug.

2. When starting from cold, press the primer bulb 3-5 times before starting the engine.

3. When starting the engine from cold, turn throttle choke lever to “ ” position. When starting a warm engine, turn throttle

lever to a mid-position.

4. Standing behind the unit, grasp the brake control handle and hold it against the upper handle as shown in Fig. 8B

5. Grasp the starter handle as shown Fig.8B and pull up rapidly. Return it slowly to the rope guide bolt after engine starts.

Releasing the brake control handle stops the engine and blade.

Fig. 8A Fig. 8B Fig. 8C

7.3 OPERATION PROCEDURES

Note: During operation, tightly hold the brake handle with both hands.

Note: During operation, when the brake handle is released, the engine will stop and thus stop the lawnmower from operating.

7.4 TO STOP ENGINE

The blade continues to rotate for a few seconds after the engine is shut off.

1. Release the brake control handle to stop the engine and blade. (Fig.9)

2. Disconnect and ground the spark plug wire as instructed in the separate engine manual to prevent accidental starting while

equipment is unattended.

Fig. 9

7.5 CONNECTION FOR AUTO DRIVE – SELF PROPELLED OPTION

Grip the Self-drive control handle, the lawnmower will move forward automatically with a speed of about 3.6km/h (Fig.10),

release the self-drive handle, the lawnmower will stop moving.