Manualshelf

Operation Manual

ManualsBrandsCobra ManualsToolsM40B
78910111213141516
11
7.8 DECK
The underside of the mower deck should be cleaned after each use to prevent a buildup of grass clippings, leaves, dirt or other
matter. If this debris is allowed to accumulate, it will invite rust and corrosion, and may prevent proper mulching. The deck may be
cleaned by tilting the mower and scraping clean with a suitable tool (make certain the spark plug wire is disconnected).
7.9 HEIGHT ADJUSTMENT INSTRUCTIONS
CAUTION: Do not at any time make any adjustment to lawnmower without first stopping the engine and disconnecting the
spark plug wire. Your mower is equipped with a central height adjustment lever offering 10 height positions. (Fig.12E)
The height (the blade to the ground) can be adjusted from 25 mm to 75 mm.
1. Stop mower and disconnect spark plug cable before changing mower cutting height.
2. The central height adjustment lever offers you 10 different height positions.
To change the height of cut, squeeze the adjuster lever towards the wheel, moving up or down to selected height.
Fig.12E
8. MAINTENANCE INSTRUCTIONS
SPARK PLUG
Use only original replacement spark plugs. For best results, replace the spark plug every 100 hours of use.
9. LUBRICATION INSTRUCTIONS
CAUTION: DISCONNECT SPARK PLUG BEFORE SERVICING.
1. WHEELS-Lubricate the ball bearings in each wheel at least once a season with a light oil.
2. ENGINE-Follow engine manual for lubrication instructions.
10. CLEANING
CAUTION: Do not hose the engine. Water can damage engine or contaminate the fuel system.
1. Wipe deck with a dry cloth.
2. Hose under deck by tilting the mower so that the spark plug is up.
10.1 ENGINE AIR CLEANER
CAUTION: Do not allow dirt or dust to clog the air filter foam element.
The engine air cleaner element must be serviced (cleaned) after 25 hours normal mowing. The foam element must be serviced
regularly if the mower is used in dry dusty conditions.
TO CLEAN THE AIR FILTER
1. Lift the tabs on top of the filter cover.
2. Remove the filter cover.
3. Wash filter element in soapy water. DO NOT USE PETROL!