User guide

CENTER FOR ALLIED HEALTH AND ATHLETICS FF&E April 24, 2014
SECTION 27 41 00 AUDIOVISUAL SYSTEMS
Marshall Craft Associates, Inc. 27 41 00-8
Project 12032
16) In the event the remote control system programming becomes compromised
during the warranty period, provide the necessary effort to make the system
fullyfunctionalonceagain.
1.08 SUBMITTALS
A. Related Sections
1. Comply with requirements of Section 01 33 00 - Submittal Procedures.
B. Submittal Data
1. Submittal data is to be submitted in a three ring binder, a continuous spiral binder, or
plastic binding that allows the booklet to lie flat while open. Each booklet shall contain
the below in the following order:
a. Cover Sheet.
1) Includenameofsupplyingcontractorandprojectname.
b. Detailed Bill of Materials.
1) Include a listing of: component quantities, equipment manufacturers, model
numbers, and description of each component being supplied, and the
specification paragraph or drawing sheet that corresponds to the product.
Failuretoprovidethisinformationwillresultintherejectionofsubmittals.
c. Product Data.
1) Include a catalog sheet per product of  equipment listed in the Detailed Bill  of
Materials,intheexactorderas theDetailedBillofMaterials.Eachcatalogsheet
shall describe mechanical, electrical and functional equipment specifications.
The catalog sheet must also include an image of the product. Photocopy
duplications of
 the manufacturer’s original equipment catalog sheets will be
allowed as long as they provide adequate clarity  of both the printed word and
graphics/pictures. If more than one product is shown on the catalog sheet the
intendedproductmustbedenotedbyeitheranarroworhighlight.
d. Authorized Distributor Certificate.
1) Recently dated (within one year from submittal date) support letter from
manufacturerstatingthatthesupplyingcontractoris anAuthorizedDistributor
oftheproductbeingsupplied.
C. Shop Drawings
1. Prior to fabrication submit contractor generated drawings for approval for all supplied
systems. These drawings shall include, but are not limited to, the following:
a. Title Sheet & Symbols Legend
b. All panels, plates, and designation strips, including details relating to terminology,
engraving, finish and color.
c. All equipment racks, cabinets, consoles, tables, carts, support bases, and
shelves.