Specifications

11
Proper Chain adjustment
Tools required for chain adjustment
19 mm wrench or socket
13 mm wrench or socket
1. Make sure that the rear wheel is aligned
properly.
2. A properly adjusted chain will have
50mm (13/8”) free movement behind
the chain block with no load on the bike.
(figure 2) Figure 2
3. Sit on the bike and verify that the chain has a
minimum of 12mm (1/2”) free movement when the
chain is at its tightest point.
4. If the chain requires adjusting, loosen the axle
with a 19 mm wrench and tighten the chain by
rotating the adjustor bolts clockwise (CW) or
loosen the chain by rotating the adjustor bolts
(CCW).
5. Retighten the axel bolt to 25 ft-lb (34 Nm).
6. Retighten the adjustor bolt
Rear Brake Maintenance
CAUTION:
Too little brake pedal free-play will allow the brake pads to drag causing the pads
to wear prematurely and possible engine component failures. Too much free-play
will not allow the rider to apply the brakes quickly.
1. Set pedal height/position first, then
2. Set pedal free play.
Brake pedal height can be adjusted with the bolt and nut located under the rear
of the brake pedal. The free-play is adjusted with the adjustable plunger on the
end of the brake pedal.